lap joint

英 [læp dʒɔɪnt]

美 [læp dʒɔɪnt]

（互）搭接（头）；叠接；搭接接头；搭接缝; 搭接接头；搭接焊缝

计算机化学

英英释义

noun

• joint made by overlapping two ends and joining them together
  Synonym:splice

双语例句

• Finite element analysis on reliability design of adhesively bonded single lap joint
  基于有限元方法的单搭接接头可靠性设计
• Improvement of Steel Wire Rope Core Belt Lacing Lap Joint Craftwork
  钢丝绳芯输送带接头搭接工艺的改进
• This paper is to discuss the interlaminar stresses of adhesive lap joint by the energy method without considering the adhesive layer.
  本文以能量法求解无胶层厚度的搭接接头的层间应力。
• The results indicate that good lap joint between aluminum and galvanized steel sheet can be made in appropriate parameters.
  试验结果表明，铝和镀锌钢能得到成形良好的搭接接头。
• Study on Laser Welding for Lap Joint of Stainless Steel 'Case
  不锈钢机匣组件激光叠接焊工艺研究
• Numerical analysis on stress distribution in single lap joint with a metal inlay
  含镶嵌块单搭接接头应力分布的数值分析
• Taking the form of lap joint as an example, the effect of final assembling deviation affect by the assembly sequence was analyzed by adopting the method of worse condition.
  以搭接接头形式为例，采用最坏情况法分析了装配顺序对最终装配偏差的影响。
• A design conception on probabilistic statistics was introduced into adhesively bonded single lap joint, and finite element method was applied to analyze the factors which have important influences on the mechanical property of adhesive joint. Using 100 samples the failure probability was concluded.
  将概率统计的设计观念引入单搭接粘接接头，通过有限元分析方法分析了对粘接接头力学性能影响较大的因素，并在抽样100次的情况下，分析了单搭接粘接接头失效的概率。
• We can obtain the good appearance and defect-free brass and aluminum alloy lap joint when selecting the appropriate parameters.
  焊接时选取合适的工艺参数，可以获得外观形貌良好且无缺陷的异种材料焊接接头。
• The shear strength and elongation of the lap joint increase with the increase of strain rate.
  焊点的剪切强度及伸长量随应变速率的增加而增加。